Easy and Quick Steps To Replace Flat Truck Tires
To experience a flat truck tire is unavoidable, thus tires just like other things would depreciate. Tires at this state should not be driven because in doing so, will cause more damage on the tire, vehicle and put the occupants in danger. Anticipating on the possibilities of having a flat tire, you should equip yourself of the basic ideas in changing a tire when it’s flat.
Before going on long drives, it is also necessary to check the current condition of your tire. It is also wise to monitor the air pressure of the spare tires that you bring along so that it will be useful in times of tire complications. It is also appropriate to bring along with you your trucks manual, flat tire kit and tire tools so that by the time you experience a flat tire the best thing you can do is to pull off the road slowly and get to a spot where you won’t be hit by other trucks. Then apply the basic step to change a flat tire. Sited below are some tips to consider in changing a flat truck tire.
1. Locate the spare tire. In truck, they are usually found mounted at the back of the vehicle. Furthermore, make sure they are in good condition. It is advisable that you check your tire air pressure conditions beforehand so that you won’t waste your time in bringing inadequate spare tires.
2. Flat tire replacement should be done on a flat surface. Make sure that the emergency break is set and the tire should be blocked using large bricks or stone to prevent it from moving when you are changing the tires. It is necessary to loosen up the wheel tugs first, using a tire iron before you jack your car or else you might rotate the wheel instead of the wheel tugs when exerting force in loosening up the tugs.
3. Once the tugs are loosened put the jack underneath your car. Just refer to your cars manual for frames in your car that are hard enough to hold the jack underneath.
4. Next is to raise the car with the jack until it is fully raised off the ground. Then remove the wheel lugs completely and set them aside first. Be sure to put them in a secured place so that it will not be lost, you still have to use it after the spare tires are placed.
5. Once the tire is off the wheel studs, replace it with the spare tire. Positioning the spare tire over the wheel studs is one of the most difficult step to be undertaken when changing a flat tire. Thus you have to fit in the holes of the wheel to the wheel studs.
6. Keep the spare tires firmly in place by screwing and tightening each wheel lug into the tire.
7. As soon as the spare tires are properly in place, you can now proceed to lowering the jack and pulling it away from the vehicle. These spare truck tires should only be used temporarily thus most spare tires have limited speed but it does help you get back to your house or to the nearest service station.
Filed under: Automotive